FreeBSD Manual Pages
CUE(4) Kernel Interfaces Manual CUE(4) NAME cue -- CATC USB-EL1210A USB Ethernet driver SYNOPSIS To compile this driver into the kernel, place the following lines in your kernel configuration file: device uhci device ohci device usb device miibus device uether device cue Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5): if_cue_load="YES" DESCRIPTION The cue driver provides support for USB Ethernet adapters based on the Computer Access Technology Corporation's USB-EL1210A chipset. The USB-EL1210A supports a 512-bit multicast hash filter, single per- fect filter entry for the station address and promiscuous mode. Pack- ets are received and transmitted over separate USB bulk transfer end- points. The CATC chipset supports only 10Mbps half-duplex mode, hence there are no ifmedia() modes to select. For more information on configuring this device, see ifconfig(8). HARDWARE The cue driver supports CATC USB-EL1210A based USB Ethernet adapters including: • Belkin F5U011/F5U111 • CATC Netmate • CATC Netmate II • SmartBridges SmartLink DIAGNOSTICS cue%d: watchdog timeout A packet was queued for transmission and a transmit command was issued, however the device failed to acknowledge the transmission before a timeout expired. cue%d: no memory for rx list The driver failed to allocate an mbuf for the receiver ring. SEE ALSO arp(4), netintro(4), ng_ether(4), ifconfig(8) HISTORY The cue device driver first appeared in FreeBSD 4.0. AUTHORS The cue driver was written by Bill Paul <wpaul@ee.columbia.edu>. FreeBSD 14.3 July 24, 2019 CUE(4)
NAME | SYNOPSIS | DESCRIPTION | HARDWARE | DIAGNOSTICS | SEE ALSO | HISTORY | AUTHORS
Want to link to this manual page? Use this URL:
<https://man.freebsd.org/cgi/man.cgi?query=cue&sektion=4&manpath=FreeBSD+14.3-RELEASE+and+Ports>