POWERD(8) System Manager's Manual POWERD(8) NAME powerd -- system power control utility SYNOPSIS powerd [-a mode] [-b mode] [-i percent] [-M freq] [-m freq] [-N] [-n mode] [-P pidfile] [-p ival] [-r percent] [-s source] [-v] DESCRIPTION The powerd utility monitors the system state and sets various power control options accordingly. It offers power-saving modes that can be individually selected for operation on AC power or batteries. maximum Choose the highest performance values. May be abbreviated as max. minimum Choose the lowest performance values to get the most power sav- ings. May be abbreviated as min. adaptive Attempt to strike a balance by degrading performance when the system appears idle and increasing it when the system is busy. It offers a good balance between a small performance loss for greatly increased power savings. May be abbreviated as adp. hiadaptive Like adaptive mode, but tuned for systems where performance and interactivity are more important than power consumption. It increases frequency faster, reduces frequency less aggres- sively, and will maintain full frequency for longer. May be abbreviated as hadp. The default mode is adaptive for battery power and hiadaptive for the rest. powerd recognizes these runtime options: -a mode Selects the mode to use while on AC power. -b mode Selects the mode to use while on battery power. -i percent Specifies the CPU load percent level when adaptive mode should begin to degrade performance to save power. The default is 50% or lower. -M freq Specifies the maximum frequency to throttle up to. -m freq Specifies the minimum frequency to throttle down to. -N Treat "nice" time as idle for the purpose of load calculation; i.e., do not increase the CPU frequency if the CPU is only busy with "nice" processes. -n mode Selects the mode to use normally when the AC line state is un- known. -P pidfile Specifies an alternative file in which the process ID should be stored. -p ival Specifies a different polling interval (in milliseconds) for AC line state and system idle levels. The default is 250 ms. -r percent Specifies the CPU load percent level where adaptive mode should consider the CPU running and increase performance. The default is 75% or higher. -s source Enforces method for AC line state refresh; by default, it is chosen automatically. The set of valid methods is sysctl, devd and apm (i386 only). -v Verbose mode. Messages about power changes will be printed to stdout and powerd will operate in the foreground. FILES /var/run/powerd.pid The default PID file. SEE ALSO acpi(4), apm(4), cpufreq(4), rc.conf(5) HISTORY The powerd utility first appeared in FreeBSD 6.0. AUTHORS Colin Percival first wrote estctrl, the utility that powerd is based on. Nate Lawson then updated it for cpufreq(4), added features, and wrote this manual page. BUGS The powerd utility should also power down idle disks and other components besides the CPU. If powerd is used with /etc/rc.d/power_profile, they may override each other. The powerd utility should probably use the devctl(4) interface instead of polling for AC line state. FreeBSD 15.1 February 25, 2023 POWERD(8)
NAME | SYNOPSIS | DESCRIPTION | FILES | SEE ALSO | HISTORY | AUTHORS | BUGS
Want to link to this manual page? Use this URL:
<https://man.freebsd.org/cgi/man.cgi?query=powerd&manpath=FreeBSD+15.1-RELEASE+and+Ports>