Skip site navigation (1)Skip section navigation (2)

  
 
  

home | help
TWS(4)			     Kernel Interfaces Manual			  TWS(4)

NAME
     tws -- 3ware 9750 SATA+SAS 6Gb/s RAID controller card driver

SYNOPSIS
     To compile this driver into the kernel, place the following lines in your
     kernel configuration file:

	   device scbus
	   device tws

     Alternatively, to load the driver as a module at boot time, place the
     following line in loader.conf(5):

	   tws_load="YES"

DESCRIPTION
     The  tws  driver  provides support for LSI's 3ware 9750 SATA+SAS 6Gb/s RAID
     controller cards.

     These controllers feature the LSISAS2108 6Gb/s SAS RAID-on-Chip  (ROC)  and
     are  available  in 4- and 8-port configurations, supports RAID levels 0, 1,
     5, 6, 10, 50 and single disk, with 96 SATA and/or SAS hard drives and SSDs.

     For further hardware information, see http://www.lsi.com/.

HARDWARE
     The tws driver supports the following SATA/SAS RAID controller:

     *	 LSI's 3ware SAS 9750 series

LOADER TUNABLES
     Tunables can be set at the loader(8) prompt before booting  the  kernel  or
     stored in loader.conf(5).

     hw.tws.cam_depth	    The  maximum  queued  CAM  SIM requests for one con-
			    troller.  The default value is 256.

     hw.tws.enable_msi	    This tunable enables MSI support on  the  controller
			    if set to a non-zero value.  The default value is 0.

     hw.tws.queue_depth     The maximum queued requests for one controller.

     hw.tws.use_32bit_sgls  Limit  the driver to use only 32-bit SG elements re-
			    gardless whether the operating system is running  in
			    64-bit mode.  The default value is 0.

FILES
     /dev/da?	array/logical disk interface
     /dev/tws?	management interface

DIAGNOSTICS
     Whenever  the  driver  encounters a command failure, it prints out an error
     code in the format: "ERROR: (<error source>: <error code>):", followed by a
     text description of the error.  There are other error messages and warnings
     that the driver prints out, depending on the kinds of errors  that  it  en-
     counters.	 If the driver is compiled with TWS_DEBUG defined, it prints out
     a whole bunch of debug messages.

SEE ALSO
     da(4), scsi(4)

AUTHORS
     The tws driver was written by Manjunath Ranganathaiah for LSI and this man-
     ual page was written by Xin LI <delphij@FreeBSD.org> for iXsystems, Inc.

FreeBSD 15.1			 October 4, 2011			  TWS(4)

Want to link to this manual page? Use this URL:
<https://man.freebsd.org/cgi/man.cgi?query=tws&sektion=4&manpath=FreeBSD+15.1-RELEASE+and+Ports>

home | help