FreeBSD Manual Pages
BLOCKLISTCTL(8) System Manager's Manual BLOCKLISTCTL(8) NAME blocklistctl -- display and change the state of the blocklistd database SYNOPSIS blocklistctl dump [-abdnrw] [-D dbname] DESCRIPTION blocklistctl is a program used to display and change the state of the blocklistd(8) database. The following sub-commands are supported: dump The following options are available for the dump sub-command: -a Show all database entries, by default it shows only the active ones. Inactive entries will be shown with a last-access (or, with -r, the remaining) time of `never'. -b Show only the blocked entries. -D dbname Specify the location of the blocklistd database file to use. The default is /var/db/blocklistd.db. -d Increase debugging level. -n Don't display a header. -r Show the remaining blocked time instead of the last activity time. -w Normally the width of addresses is good for IPv4, the -w flag, makes the display wide enough for IPv6 addresses. The output of the dump sub-command consists of a header (unless -n was given) and one line for each record in the database, where each line has the following columns: `rulename' The packet filter rule name associated with the database entry, usually blocklistd. `address/ma:port' The remote address, mask, and local port number of the client con- nection associated with the database entry. `id' column will show the identifier for the packet filter rule associ- ated with the database entry, though this may only be the word `OK' for packet filters which do not create a unique identifier for each rule. `nfail' The number of failures reported for the client on the noted port, as well as the number of failures allowed before blocking (or, with -a, an asterisk <*>) `last access' | `remaining time' The last time a the client was reported as attempting access, or, with -r, the time remaining before the rule blocking the client will be removed. SEE ALSO blocklistd(8) NOTES Sometimes the reported number of failed attempts can exceed the number of attempts that blocklistd(8) is configured to block. This can happen either because the rule has been removed manually, or because there were more at- tempts in flight while the rule block was being added. This condition is normal; in that case blocklistd(8) will first attempt to remove the exist- ing rule, and then it will re-add it to make sure that there is only one rule active. HISTORY blocklistctl first appeared in NetBSD 7. FreeBSD support for blocklistctl was implemented in FreeBSD 11. AUTHORS Christos Zoulas FreeBSD ports 15.quarterly October 25, 2025 BLOCKLISTCTL(8)
NAME | SYNOPSIS | DESCRIPTION | SEE ALSO | NOTES | HISTORY | AUTHORS
Want to link to this manual page? Use this URL:
<https://man.freebsd.org/cgi/man.cgi?query=blocklistctl&sektion=8&manpath=FreeBSD+15.1-RELEASE+and+Ports.quarterly>