FreeBSD Manual Pages
NTB_HW_PLX(4) Kernel Interfaces Manual NTB_HW_PLX(4) NAME ntb_hw_plx -- PLX/Avago/Broadcom Non-Transparent Bridge driver SYNOPSIS To compile this driver into your kernel, place the following lines in your kernel configuration file: device ntb device ntb_hw_plx Or, to load the driver as a module at boot, place the following line in loader.conf(5): ntb_hw_plx_load="YES" The following tunables are settable from the loader(8): hint.ntb_hw.X.b2b Being set to 1 (default) tells the driver attached to Virtual Interface of the NTB that it works in NTB-to-NTB (back-to-back) mode, 0 -- NTB-to-Root Port. Driver attached to Link Interface (visible from Root Port side) switches to NTB-to-Root Port mode automatically, but one attached to Virtual Interface can't detect what is on the other side and require external knowledge. hint.ntb_hw.X.split Being set above zero splits BAR2 into 2^x memory windows using Address Lookup Table (A-LUT). DESCRIPTION The ntb_hw_plx driver provides support for the Non-Transparent Bridge (NTB) hardware in PLX PCIe bridge chips, which allow up to two of their PCIe ports to be switched from transparent to non-transparent bridge mode. In this mode bridge looks not as a PCI bridge, but as PCI endpoint device. The driver hides hardware details, exposing memory windows, scratchpads and doorbells of the other side via hardware independent KPI to ntb(4) subsys- tem. Each PLX NTB provides up to 2 64-bit or 4 32-bit memory windows to the other system's memory, 6 or 12 scratchpad registers and 16 doorbells to in- terrupt the other system. If Address Lookup Table (A-LUT) is enabled, BAR2 can be split into several (up to 128) memory windows. In NTB-to-NTB mode one of memory windows (or half of it, if bigger then 1MB) is consumed by the driver itself to access scratchpad and doorbell registers of the other side. HARDWARE The following PLX/Avago/Broadcom chips are supported by the ntb_hw_plx dri- ver: * PEX 8713 * PEX 8717 * PEX 8725 * PEX 8733 * PEX 8749 , but it may also work with other compatible ones. CONFIGURATION The basic chip configuration should be done by serial EEPROM or via i2c. It includes enabling NTB on one or both sides (choosing between NTB-to-NTB (back-to-back) and NTB-to-Root Port modes) and configuring BARs sizes. The recommended mode is NTB-to-NTB mode, since while NTB-to-Root Port is generally supported by the driver, it require PCI hotplug handling on the Root Port, that may be difficult or cause different kinds of problems. SEE ALSO if_ntb(4), ntb(4), ntb_transport(4) AUTHORS The ntb_hw_plx driver was written by Alexander Motin <mav@FreeBSD.org>. BUGS There is no way to protect your system from malicious behavior on the other system once the link is brought up. Anyone with root or kernel access on the other system can read or write to any location on your system. In other words, only connect two systems that completely trust each other. FreeBSD ports 15.quarterly November 9, 2019 NTB_HW_PLX(4)
NAME | SYNOPSIS | DESCRIPTION | HARDWARE | CONFIGURATION | SEE ALSO | AUTHORS | BUGS
Want to link to this manual page? Use this URL:
<https://man.freebsd.org/cgi/man.cgi?query=ntb_hw_plx&sektion=4&manpath=FreeBSD+15.1-RELEASE+and+Ports.quarterly>