home | help
EX(4)			  i386 Kernel Interfaces Manual 		   EX(4)

NAME
     ex -- Ethernet device driver for the Intel EtherExpress Pro/10 and Pro/10+

SYNOPSIS
     device ex0 at isa? port? irq ?

DESCRIPTION
     The ex driver provides support for the 16-bit PCI Intel EtherExpress Pro/10
     and Pro/10+ Ethernet cards based on the Intel i82595 chip.

     If the port start address isn't found, the card will be searched for in the
     I/O  address  range  0x200 - 0x3a0.  If the IRQ isn't specified, it will be
     read from the EEPROM on the card.	For correct operation on newer cards the
     Plug-N-Play support should be disabled.

DIAGNOSTICS
     ex%d: Intel EtherExpress Pro/10, address %6D,  connector  %s    The  device
     probe found an installed card, and was able to correctly install the device
     driver.

     ex%d:  WARNING:  board's EEPROM is configured for IRQ %d, using %d  The de-
     vice probe detected that the board is configured for a different  interrupt
     than the one specified in the kernel configuration file.

     ex%d: invalid IRQ.  The device probe detected an invalid IRQ setting.

BUGS
     Currently the driver does not support multicast.

SEE ALSO
     arp(4), netintro(4), ng_ether(4), ifconfig(8)

HISTORY
     The ex device driver first appeared in FreeBSD 2.2.

AUTHORS
     The  ex device driver was written by Javier Martin Rueda.	This manual page
     was written by David E. O'Brien.

FreeBSD 4.5			January 19, 1997			   EX(4)

home | help