home | help
IPS(4)			     Kernel Interfaces Manual			  IPS(4)

NAME
     ips -- IBM/Adaptec ServeRAID controller driver

SYNOPSIS
     device scbus
     device ips

DESCRIPTION
     The  ips  driver  claims  to support the IBM (now Adaptec) ServeRAID series
     SCSI controller cards.  Some supported devices include:

     IBM ServeRAID 3H
     ServeRAID 4L/4M/4H
     ServeRAID Series 5
     ServeRAID 6i/6M

     These cards come with a  built  in  configuration	utility  stored  in  the
     firmware known as the ISPR.  This utility is accessed with the CTRL + I key
     combination during the initial card POST.

     It  is  highly  recommended that this utility be used to configure the card
     before attempting to diagnose the below error messages.

     In some cases, the ips driver can have difficulties  attaching  during  the
     system initialization period.  To avoid these difficulties, set the
	   hw.ips.0.disable
     tunable to "1".  This MIB prevents the driver from attaching.

DIAGNOSTICS
     Several  error  codes  may  be shown when the card initializes the IBM ISPR
     utility and are independent of FreeBSD.

     ips%d: failed to get adapter configuration data from device
     ips%d: failed to get drive configuration data from device

     Unable to obtain adapter or drive configuration.

     ips%d iobuf error

     A buffer input/output error has occurred.	[ENXIO]

   General adapter errors:
     Attaching bus failed

     This message is undocumented.

     WARNING: command timeout. Adapter is in toaster mode, resetting

     A command timeout has caused the adapter to be reset.

     AIEE! adapter reset failed, giving up and going home! Have a nice day

     An error occurred while attempting to reset the adapter.

     unable to get adapter configuration
     unable to get drive configuration

     There was an error when attempting to get configuration information.

     Adapter error during initialization.
     adapter initialization failed

     There was an error while attempting to initialize the adapter.

     adapter failed config check
     adapter clear failed

     There was an error while checking the adapter.

     device is disabled

     The adapter is disabled.

     resource allocation failed
     irq allocation failed
     irq setup failed

     The driver was unable to allocate resources for the device.

   Error messages due to DMA:
     can't alloc command dma tag
     can't alloc SG dma tag
     can't alloc dma tag for statue queue
     dmamap failed

     Failure to map or allocate DMA resources.

   Cache, buffer, and command errors:
     failed to initialize command buffers
     no mem for command slots!

     The ips driver will return [ENOMEM] in such cases.

     ERROR: unable to get a command! can't flush cache!
     ERROR: cache flush command failed!
     ERROR: unable to get a command! can't update nvram
     ERROR: nvram update command failed!
     ERROR: unable to get a command! can't sync cache!
     ERROR: cache sync command failed!
     ERROR: unable to get a command! can't sync cache!
     ERROR: etable command failed!

COMPATIBILITY
     Unlike many of the other SCSI devices in FreeBSD, the ips driver  does  not
     use the cam(4) SCSI subsystem.

SEE ALSO
     ch(4), da(4), sysctl(8)

AUTHORS
     The   ips	 driver   was	written   by   David  Jefferys	and  Scott  Long
     <scottl@FreeBSD.org>.

     This manual page was written by Tom Rhodes <trhodes@FreeBSD.org>.

FreeBSD 5.2.1			November 11, 2003			  IPS(4)

home | help