home | help
AXE(4)			     Kernel Interfaces Manual			  AXE(4)

NAME
     axe -- ASIX Electronics AX88172 USB Ethernet driver

SYNOPSIS
     device ehci
     device uhci
     device ohci
     device usb
     device miibus
     device axe

DESCRIPTION
     The axe driver provides support for USB ethernet adapters based on the ASIX
     Electronics AX88172 USB 2.0 chipset, including the following:

     *	 D-Link DUBE100
     *	 LinkSys USB200M
     *	 Netgear FA120

     The  AX88172  is a USB 2.0 device which contains a 10/100 ethernet MAC with
     MII interface and is designed to work with both ethernet and HomePNA trans-
     ceivers.  The AX88172 will operate with both  USB	1.x  and  USB  2.0  con-
     trollers,	however performace with 1.x contollers will be limited since the
     USB 1.x standard specifies a maximum transfer speed of 12Mbps.  Users  with
     USB 1.x controllers should therefore not expect to actually achieve 100Mbps
     speeds with these devices.

     The  AX88172  supports a 64-bit multicast hash table, single perfect filter
     entry for the station address, all-multicast  mode  and  promiscuous  mode.
     Packets  are  received and transmitted over separate USB bulk transfer end-
     points.

     The axe driver supports the following media types:

     autoselect   Enable autoselection of the media type and options.  The  user
		  can  manually  override  the autoselected mode by adding media
		  options to the /etc/rc.conf file.

     10baseT/UTP  Set 10Mbps operation.  The mediaopt option can also be used to
		  enable full-duplex operation.  Not specifying full-duplex  im-
		  plies half-duplex mode.

     100baseTX	  Set  100Mbps	(fast  ethernet) operation.  The mediaopt option
		  can also be used to enable full-duplex operation.  Not  speci-
		  fying full-duplex implies half-duplex mode.

     The axe driver supports the following media options:

     full-duplex  Force  full  duplex  operation.  The interface will operate in
		  half duplex mode if this media option is not specified.

     For more information on configuring this device, see ifconfig(8).

DIAGNOSTICS
     axe%d: watchdog timeout  A packet was queued for transmission and a  trans-
     mit command was issued, however the device failed to acknowledge the trans-
     mission before a timeout expired.

     axe%d: no memory for rx list  The driver failed to allocate an mbuf for the
     receiver ring.

SEE ALSO
     arp(4), miibus(4), netintro(4), ng_ether(4), ifconfig(8)

     ASIX AX88172 data sheet, http://www.asix.com.tw.

HISTORY
     The axe device driver first appeared in FreeBSD 5.0.

AUTHORS
     The axe driver was written by Bill Paul <wpaul@windriver.com>.

FreeBSD 5.2.1			 April 20, 2003 			  AXE(4)

home | help