home | help
CM(4)			     Kernel Interfaces Manual			   CM(4)

NAME
     cm -- SMC Arcnet Ethernet device driver

SYNOPSIS
     device isa
     device cm

DESCRIPTION
     The cm driver provides support for the Arcnet ISA network adapters.

     This driver also has quirks preset in the device.hints(5) file for card de-
     tection.

HARDWARE
     The cm driver supports the following card models:

     *	 SMC90c26
     *	 SMC90c56
     *	 SMC90c66 in '56 compatibility mode.

IMPLEMENTATION NOTES
     When  the NOARP flag is set on the cm interface, it does not employ the ad-
     dress resolution protocol described in arp(4) to  dynamically  map  between
     Internet  and Ethernet addresses on the local network.  Instead it uses the
     least significant 8 bits of the IP address as the hardware address like de-
     scribed in RFC 1051 and RFC 1201.

     With the IFF_LINK0 flag cleared IP/ARP/RARP encoding is done  according  to
     RFC  1201 that is, with Packet Header Definition Standard header and packet
     type 212 / 213.  The MTU is normally 1500.  The IFF_LINK0 flag  is  cleared
     by default.

     With  the	IFF_LINK0 flag set, IP and ARP encoding is done according to the
     deprecated RFC 1051 encoding, that is with simple header, packet type 240 /
     241, and the MTU is 507.

     When switching between the two modes, use
	   ifconfig interfacename down up
     to switch the MTU.

DIAGNOSTICS
     The following driver specific error messages may be reported:

     reset: card reset, link addr = 0x%02x (cm%d)  The card is being reset and a
     new link address assigned.

     srint: restarted rx on buf cm%d  The rx buffer has been emptied and will be
     reset.

SEE ALSO
     netintro(4), watchdog(4), device.hints(5), ifconfig(8), watchdog(8)

HISTORY
     The cm device was ported from NetBSD by  Max  Khon  <fjoe@FreeBSD.org>  and
     first  appeared  in  FreeBSD  4.6.   This	manual	page  first  appeared in
     FreeBSD 5.3.

AUTHORS
     This manual page was written  by  Tom  Rhodes  <trhodes@FreeBSD.org>.   The
     "IMPLEMENTATION NOTES" section was submitted by
     Max Khon <fjoe@FreeBSD.org> and originated from NetBSD.

BUGS
     The  cm driver code could do with a bit of improvement, it would be nice if
     some one could come along and take care of this.

     The "IMPLEMENTATION NOTES" section is specific to all Arcnet  devices  (see
     sys/net/if_arcsubr.c) and should be moved to a more generic location.

FreeBSD 5.4			  July 28, 2004 			   CM(4)

home | help