home | help
RFCOMM_SPPD(1)		     General Commands Manual		  RFCOMM_SPPD(1)

NAME
     rfcomm_sppd -- RFCOMM Serial Port Profile daemon

SYNOPSIS
     rfcomm_sppd [-bh] -a address -c channel [-t tty]

DESCRIPTION
     The  rfcomm_sppd  utility is a Serial Port Profile daemon.  It opens RFCOMM
     connection to the specified address server and channel.  Once connection is
     established, the rfcomm_sppd utility provides access to the server's remote
     serial port via stdin/stdout or via pty(4) interface if -t option was spec-
     ified.

     The rfcomm_sppd utility opens both master and slave pseudo terminals.  This
     is done to ensure that RFCOMM connection stays open  until  rfcomm_sppd  is
     terminated.   The	data  received	from the master pseudo terminal are sent
     over the RFCOMM connection.  The data received from the  RFCOMM  connection
     are written into master pseudo terminal.  The application in its turn opens
     the  slave  pseudo  terminal  and operates on it just like it would operate
     over the standard serial port.

     The options are as follows:

     -a address
	     This required option specifies the address  of  the  remote  RFCOMM
	     server.   The address can be specified as BD_ADDR or name.  If name
	     was specified then the rfcomm_sppd utility will attempt to  resolve
	     the name via bt_gethostbyname(3).

     -b      Detach from the controlling terminal, i.e., run in background.

     -c channel
	     This option specifies RFCOMM channel to connect to.  RFCOMM channel
	     could  either be a number between 1 and 30 or a service name.  Sup-
	     ported service names are: DUN (for DialUp Networking service),  FAX
	     (for  Fax	service),  LAN (for LAN Access Using PPP service) and SP
	     (for Serial Port service).   If  channel  was  not  specified  then
	     rfcomm_sppd  utility  will  try to obtain RFCOMM channel for Serial
	     Port service via Service Discovery Protocol from the server.

     -h      Display usage message and exit.

     -t tty  Slave pseudo tty name.  If not set stdin/stdout will be used.  This
	     option is required if -b option was specified.

FILES
     /dev/pty[p-sP-S][0-9a-v]  master pseudo terminals
     /dev/tty[p-sP-S][0-9a-v]  slave pseudo terminals

EXIT STATUS
     The rfcomm_sppd utility exits 0 on success, and >0 if an error occurs.

EXAMPLES
	   rfcomm_sppd -a 00:01:02:03:04:05 -c 1 -t /dev/ttyp1

     Will start the rfcomm_sppd utility and open RFCOMM connection to the server
     at 00:01:02:03:04:05 and channel 1.  Once the connection  has  been  estab-
     lished,  /dev/ttyp1  can  be  used to talk to the remote serial port on the
     server.

SEE ALSO
     bluetooth(3), ng_btsocket(4), pty(4), rfcomm_pppd(8)

AUTHORS
     Maksim Yevmenkin <m_evmenkin@yahoo.com>

BUGS
     Please report if found.

FreeBSD 6.1			 April 26, 2003 		  RFCOMM_SPPD(1)

home | help