home | help
POWERD(8)		     System Manager's Manual		       POWERD(8)

NAME
     powerd -- system power control utility

SYNOPSIS
     powerd [-a mode] [-b mode] [-i percent] [-n mode] [-p ival] [-P pidfile]
	    [-r percent] [-v]

DESCRIPTION
     The powerd utility monitors the system state and sets various power control
     options  accordingly.   It  offers three modes (maximum, minimum, and adap-
     tive) that can be individually selected while on  AC  power  or  batteries.
     The modes maximum, minimum, adaptive and hiadaptive may be abbreviated max,
     min, adp, hadp.

     Maximum  mode chooses the highest performance values.  Minimum mode selects
     the lowest performance values to get the most power savings.  Adaptive mode
     attempts to strike a balance by degrading performance when the  system  ap-
     pears  idle  and  increasing  it when the system is busy.	It offers a good
     balance between a small performance loss for greatly increased  power  sav-
     ings.   Hiadaptive mode is alike adaptive mode, but tuned for systems where
     performance and interactivity are more important  then  power  consumption.
     It  rises	frequency  faster,  drops slower and keeps twice lower CPU load.
     The default mode is adaptive for battery power and hiadaptive for the rest.

     The powerd utility recognizes the following runtime options:

     -a mode	 Selects the mode to use while on AC power.

     -b mode	 Selects the mode to use while on battery power.

     -i percent  Specifies the CPU load percent level when adaptive mode  should
		 begin to degrade performance to save power.  The default is 50%
		 or lower.

     -n mode	 Selects  the mode to use normally when the AC line state is un-
		 known.

     -p ival	 Specifies a different polling interval (in milliseconds) for AC
		 line state and system idle levels.  The default is 250 ms.

     -P pidfile  Specifies an alternative file in which the process ID should be
		 stored.  The default is /var/run/powerd.pid.

     -r percent  Specifies the CPU load percent level where adaptive mode should
		 consider the CPU running and increase performance.  The default
		 is 75% or higher.

     -v 	 Verbose mode.	Messages about power changes will be printed  to
		 stdout and powerd will operate in the foreground.

SEE ALSO
     acpi(4), apm(4), cpufreq(4)

HISTORY
     The powerd utility first appeared in FreeBSD 6.0.

AUTHORS
     Colin  Percival  first  wrote estctrl, the utility that powerd is based on.
     Nate Lawson then updated it for cpufreq(4), added features, and wrote  this
     manual page.

BUGS
     The  powerd  utility should also power down idle disks and other components
     besides the CPU.

     If powerd is used with power_profile, they may override each other.

     The powerd utility should probably use the devctl(4) interface  instead  of
     polling for AC line state.

FreeBSD 7.2			December 24, 2008		       POWERD(8)

home | help