FreeBSD Manual Pages
ciscoconfr(8) System Manager's Manual ciscoconfr(8) NAME ciscoconfr SYNOPSIS ciscoconfr router log-entry AVAILABILITY This program has been installed successfully on FreeBSD 2.2.6-RELEASE, Linux RedHat 4.2, Solaris 2.5.1, IRIX 5.3 and HP/UX 10.20. Feedback re- garding other platforms is welcome. DESCRIPTION ciscoconfr will retrieve configuration from a Cisco router using rsh(1), and store it under RCS source control in the directory /usr/lo- cal/share/cisco (this directory was specified on this host at install time). Blank lines, comments and other garbage are automagically pruned from the router configuration to prevent unnecessary RCS deltas being formed from insignificant changes. ciscoconfr is intended to be run automatically by ciscoconfd(8) to maintain a configuration history for multiple routers. Parameters for ciscoconfr are as follows: router A router's host name in a format suitable to be passed to rsh(1) log-entry A log entry to provide supporting information when checking the changed configuration in using ci(1) ROUTER CONFIGURATION The user which ciscologr runs as must be permitted to issue enable com- mands to routers using rsh(1). To allow this to happen, some configu- ration of the appropriate routers is necessary. The following example allows the user "jabley" to issue enable-mode commands via rsh from the host 203.97.2.226: ip rcmd rsh-enable ip rcmd remote-host jabley 203.97.2.226 jabley enable SECURITY Warning! Do not type these commands into your router without a thor- ough understanding of the security implications for your network. VERSION 1.00 (6 Apr 1998) More recent versions may be available; check for details at http://www.patho.gen.nz/~jabley/ BUGS If a router's non-volatile RAM is otherwise engaged (e.g. by a "write mem" issued by an operator, or by a slave-sync in units with multiple route processors), the configuration retrieved from the router will be the single line `Non-Volatile memory is in use' . This should only happen infrequently as long as ciscologr(8) is not run so often that the instinctive post-configuration "write mem" is always caught. Frequency of running ciscologr can be reduced by sensible application of the -t parameter to ciscologd(8). SEE ALSO ciscoconfd(8), rsh(1), ci(1), co(1) AUTHOR Joe Abley <jabley@automagic.org> 6 Apr 1998 ciscoconfr(8)
NAME | SYNOPSIS | AVAILABILITY | DESCRIPTION | ROUTER CONFIGURATION | SECURITY | VERSION | BUGS | SEE ALSO | AUTHOR
Want to link to this manual page? Use this URL:
<https://man.freebsd.org/cgi/man.cgi?query=ciscoconfr&sektion=8&manpath=FreeBSD+Ports+15.0>