Skip site navigation (1)Skip section navigation (2)

FreeBSD Manual Pages

  
 
  

home | help
RSU(4)			     Kernel Interfaces Manual			  RSU(4)

NAME
     rsu  --  Realtek  RTL8188SU/RTL8192SU USB IEEE 802.11b/g/n wireless network
     driver

SYNOPSIS
     To compile this driver into the kernel, place the following lines in your
     kernel configuration file:

	   device ehci
	   device uhci
	   device ohci
	   device usb
	   device rsu
	   device rsufw
	   device wlan

     Alternatively, to load the driver as a module at boot time, place the
     following lines in loader.conf(5):

	   if_rsu_load="YES"
	   rsu-rtl8712fw_load="YES"

DESCRIPTION
     The rsu driver supports USB 2.0 wireless network devices based  on  Realtek
     RTL8188SU, RTL8191SU and RTL8192SU chipsets.

     The RTL8188SU is a highly integrated 802.11n adapter that combines a MAC, a
     1T1R  capable baseband and an RF in a single chip.  It operates in the 2GHz
     spectrum only.

     The RTL8191SU is a highly integrated multiple-in, single-out (MISO) 802.11n
     adapter that combines a MAC, a 1T2R capable baseband and an RF in a  single
     chip.  It operates in the 2GHz spectrum only.

     The  RTL8192SU  is  a  highly  integrated	multiple-in, multiple-out (MIMO)
     802.11n adapter that combines a MAC, a 2T2R capable baseband and an RF in a
     single chip.  It operates in the 2GHz spectrum only.

     These are the modes the rsu driver can operate in:

     BSS mode	    Also known as infrastructure mode, this is used when associ-
		    ating with	an  access  point,  through  which  all  traffic
		    passes.  This mode is the default.

     monitor mode   In	this  mode the driver is able to receive packets without
		    associating with an access point.  This disables the  inter-
		    nal  receive  filter and enables the card to capture packets
		    from networks which it wouldn't normally have access to,  or
		    to scan for access points.

     The  rsu  driver can be configured to use Wired Equivalent Privacy (WEP) or
     Wi-Fi Protected Access (WPA-PSK and WPA2-PSK).  WPA is the de facto encryp-
     tion standard for wireless networks.  It is strongly recommended  that  WEP
     not  be used as the sole mechanism to secure wireless communication, due to
     serious weaknesses in it.

     The rsu driver can be configured at runtime with ifconfig(8).

HARDWARE
     The rsu driver provides support for Realtek  RTL8188SU/RTL8192SU  USB  IEEE
     802.11b/g/n wireless network adapters, including:

	   *   ASUS USB-N10
	   *   ASUS WL-167G V3
	   *   Belkin F7D1101 v1
	   *   D-Link DWA-131 A1
	   *   EDUP EP-MS150N(W)
	   *   Edimax EW-7622UMN
	   *   Hercules HWGUn-54
	   *   Hercules HWNUm-300
	   *   Planex GW-USNano
	   *   Sitecom WL-349 v1
	   *   Sitecom WL-353
	   *   Sitecom WLA-1100 v1001
	   *   Sweex LW154
	   *   TRENDnet TEW-646UBH
	   *   TRENDnet TEW-648UB
	   *   TRENDnet TEW-649UB

FILES
     /usr/share/doc/legal/realtek.LICENSE  rsu firmware license

     The driver needs at least version 1.2 of the following firmware file, which
     is loaded when an interface is attached:

	   /boot/kernel/rsu-rtl8712fw.ko

EXAMPLES
     Join an existing BSS network (i.e., connect to an access point):

	   ifconfig wlan create wlandev rsu0 inet 192.0.2.20/24

     Join a specific BSS network with network name my_net:

	   ifconfig wlan create wlandev rsu0 ssid my_net up

     Join a specific BSS network with 64-bit WEP encryption:

	   ifconfig wlan create wlandev rsu0 ssid my_net \
	       wepmode on wepkey 0x1234567890 weptxkey 1 up

DIAGNOSTICS
     %s: failed load firmware of file rsu-rtl8712fw  For some reason, the driver
     was  unable to read the microcode file from the filesystem.  The file might
     be missing or corrupted.

     device timeout  A frame dispatched to the hardware for transmission did not
     complete in time.	The driver will reset the  hardware.   This  should  not
     happen.

SEE ALSO
     intro(1),	netintro(4),  rsufw(4),  usb(4), wlan(4), networking(7), arp(8),
     hostapd(8), ifconfig(8), wpa_supplicant(8)

HISTORY
     The rsu driver first appeared in OpenBSD 4.9 and FreeBSD 10.0.

AUTHORS
     The rsu driver was written by  Damien  Bergamini  <damien@openbsd.org>  and
     ported by Rui Paulo <rpaulo@freebsd.org>.	The 802.11n support was added by
     Adrian Chadd <adrian@freebsd.org>.

CAVEATS
     The rsu driver currently does not support 802.11n transmit aggregation, ei-
     ther A-MSDU or A-MPDU.

     The  rsu  driver  does  not capture management frames in non-monitor modes;
     without this limitation some firmware functions (e.g., 'join bss') will not
     work properly.

FreeBSD ports 15.1		  April 1, 2025 			  RSU(4)

Want to link to this manual page? Use this URL:
<https://man.freebsd.org/cgi/man.cgi?query=rsu&sektion=4&manpath=FreeBSD+15.1-RELEASE+and+Ports>

home | help