FreeBSD Manual Pages
SIIS(4) Kernel Interfaces Manual SIIS(4) NAME siis -- SiliconImage Serial ATA Host Controller driver SYNOPSIS To compile this driver into the kernel, place the following lines in your kernel configuration file: device pci device scbus device siis Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5): siis_load="YES" The following tunables are settable from the loader(8): hint.siis.X.msi controls Message Signaled Interrupts (MSI) usage by the specified controller. hint.siisch.X.pm_level controls SATA interface Power Management for the specified channel, allowing some power to be saved at the cost of additional command latency. Possible values: 0 interface Power Management is disabled (default); 1 device is allowed to initiate PM state change, host is passive. Note that interface Power Management is not compatible with device presence detection. A manual bus reset is needed on device hot-plug. hint.siisch.X.sata_rev setting to nonzero value limits maximum SATA revision (speed). Values 1, 2 and 3 are respectively 1.5, 3 and 6Gbps. DESCRIPTION This driver provides the CAM(4) subsystem with native access to the SATA ports of controller. Each SATA port is represented to CAM as a separate bus with 16 targets. Most of the bus-management details are handled by the SATA-specific transport of CAM. Connected ATA disks are handled by the ATA protocol disk peripheral driver ada(4). ATAPI devices are handled by the SCSI protocol peripheral drivers cd(4), da(4), sa(4), etc. Driver features include support for Serial ATA and ATAPI devices, Port Mul- tipliers (including FIS-based switching), hardware command queues (31 com- mand per port), Native Command Queuing, SATA interface Power Management, device hot-plug and Message Signaled Interrupts. The activity LEDs of the adapters supported by the siis driver can be con- trolled via the led(4) API for localization or status reporting purposes. HARDWARE The siis driver supports the following controller chips: * SiI3124 (PCI-X 133MHz/64bit, 4 ports) * SiI3131 (PCIe 1.0 x1, 1 port) * SiI3132 (PCIe 1.0 x1, 2 ports) * SiI3531 (PCIe 1.0 x1, 1 port) FILES /dev/led/siisch* identification LED device nodes SEE ALSO ada(4), ata(4), cam(4), cd(4), da(4), led(4), sa(4) HISTORY The siis driver first appeared in FreeBSD 8.0. AUTHORS Alexander Motin <mav@FreeBSD.org> FreeBSD ports 15.1 March 23, 2015 SIIS(4)
NAME | SYNOPSIS | DESCRIPTION | HARDWARE | FILES | SEE ALSO | HISTORY | AUTHORS
Want to link to this manual page? Use this URL:
<https://man.freebsd.org/cgi/man.cgi?query=siis&sektion=4&manpath=FreeBSD+15.1-RELEASE+and+Ports>