VKBD(4) Kernel Interfaces Manual VKBD(4) NAME vkbd -- the virtual AT keyboard interface SYNOPSIS device vkbd DESCRIPTION The vkbd interface is a software loopback mechanism that can be loosely de- scribed as the virtual AT keyboard analog of the pty(4), that is, vkbd does for virtual AT keyboards what the pty(4) driver does for terminals. The vkbd driver, like the pty(4) driver, provides two interfaces: a key- board interface like the usual facility it is simulating (a virtual AT key- board in the case of vkbd, or a terminal for pty(4)), and a character-spe- cial device "control" interface. The virtual AT keyboards are named vkbd0, vkbd1, etc., one for each control device that has been opened. The vkbd interface permits opens on the special control device /dev/vkbdctl. When this device is opened, vkbd will return a handle for the lowest unused vkbdctl device (use devname(3) to determine which). Each virtual AT keyboard supports the usual keyboard interface ioctl(2)s, and thus can be used with kbdcontrol(1) like any other keyboard. The con- trol device supports exactly the same ioctl(2)s as the virtual AT keyboard device. Writing AT scan codes to the control device generates an input on the virtual AT keyboard, as if the (non-existent) hardware had just re- ceived it. The virtual AT keyboard control device, normally /dev/vkbdctl<N>, is exclu- sive-open (it cannot be opened if it is already open) and is restricted to the super-user. A read(2) call will return the virtual AT keyboard status structure (defined in <dev/vkbd/vkbd_var.h>) if one is available; if not, it will either block until one is or return EWOULDBLOCK, depending on whether non-blocking I/O has been enabled. A write(2) call passes AT scan codes to be "received" from the virtual AT keyboard. Each AT scan code must be passed as unsigned int. Although AT scan codes must be passes as unsigned ints, the size of the buffer passed to write(2) still should be in bytes, i.e., static unsigned int codes[] = { /* Make Break */ 0x1e, 0x9e }; int main(void) { int fd, len; fd = open("/dev/vkbdctl0", O_RDWR); if (fd < 0) err(1, "open"); /* Note sizeof(codes) - not 2! */ len = write(fd, codes, sizeof(codes)); if (len < 0) err(1, "write"); close(fd); return (0); } Write will block if there is not enough space in the input queue. The control device also supports select(2) for read and write. On the last close of the control device, the virtual AT keyboard is re- moved. All queued scan codes are thrown away. SEE ALSO kbdcontrol(1), atkbdc(4), psm(4), syscons(4), vt(4) HISTORY The vkbd module was implemented in FreeBSD 6.0. AUTHORS Maksim Yevmenkin <m_evmenkin@yahoo.com> CAVEATS The vkbd interface is a software loopback mechanism, and, thus ddb(4) will not work with it. Current implementation of the syscons(4) driver can ac- cept input from only one keyboard, even if it is virtual. Thus it is not possible to have both wired and virtual keyboard to be active at the same time. It is, however, in principal possible to obtain AT scan codes from the different sources and write them into the same virtual keyboard. The virtual keyboard state synchronization is the user's responsibility. FreeBSD 15.1 August 12, 2004 VKBD(4)
NAME | SYNOPSIS | DESCRIPTION | SEE ALSO | HISTORY | AUTHORS | CAVEATS
Want to link to this manual page? Use this URL:
<https://man.freebsd.org/cgi/man.cgi?query=vkbd&sektion=4&manpath=FreeBSD+15.1-RELEASE+and+Ports>