FreeBSD Manual Pages
CUE(4) BSD Kernel Interfaces Manual CUE(4) NAME cue -- CATC USB-EL1210A USB Ethernet driver SYNOPSIS To compile this driver into the kernel, place the following lines in your kernel configuration file: device uhci device ohci device usb device miibus device uether device cue Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5): if_cue_load="YES" DESCRIPTION The cue driver provides support for USB Ethernet adapters based on the Computer Access Technology Corporation's USB-EL1210A chipset. The USB-EL1210A supports a 512-bit multicast hash filter, single perfect filter entry for the station address and promiscuous mode. Packets are received and transmitted over separate USB bulk transfer endpoints. The CATC chipset supports only 10Mbps half-duplex mode, hence there are no ifmedia() modes to select. For more information on configuring this device, see ifconfig(8). HARDWARE The cue driver supports CATC USB-EL1210A based USB Ethernet adapters in- cluding: o Belkin F5U011/F5U111 o CATC Netmate o CATC Netmate II o SmartBridges SmartLink DIAGNOSTICS cue%d: watchdog timeout A packet was queued for transmission and a transmit command was issued, however the device failed to acknowledge the transmission before a timeout expired. cue%d: no memory for rx list The driver failed to allocate an mbuf for the receiver ring. SEE ALSO arp(4), netintro(4), ng_ether(4), ifconfig(8) HISTORY The cue device driver first appeared in FreeBSD 4.0. AUTHORS The cue driver was written by Bill Paul <wpaul@ee.columbia.edu>. BSD July 24, 2019 BSD
NAME | SYNOPSIS | DESCRIPTION | HARDWARE | DIAGNOSTICS | SEE ALSO | HISTORY | AUTHORS
Want to link to this manual page? Use this URL:
<https://man.freebsd.org/cgi/man.cgi?query=cue&sektion=4&manpath=FreeBSD+13.0-RELEASE+and+Ports>