Skip site navigation (1)Skip section navigation (2)

FreeBSD Manual Pages

  
 
  

home | help 
ENIC(4)			    Kernel Interfaces Manual		       ENIC(4)

NAME
       enic -- VIC Ethernet NIC	driver

SYNOPSIS
       To  compile  this  driver into the kernel, place	the following lines in
       your kernel configuration file:

	     device iflib
	     device enic

       To load the driver as a module at run-time, run the  following  command
       as root:

	     kldload if_enic

       To  load	the driver as a	module at boot time, place the following lines
       in loader.conf(5):

	     if_enic_load="YES"

DESCRIPTION
       The enic	driver provides	support	 for  Cisco  Virtual  Interface	 Card.
       Support	is limited to basic network connectivity.  Media is controlled
       by the NIC itself since there can be multiple virtual PCI  NIC  devices
       exposed to the PCI bus.

HARDWARE
       The enic	driver should supports all known Cisco VIC cards.

CONFIGURATION
       The  enic  network  interface  is  configured using ifconfig(8) and the
       sysctl(8) tree at dev.enic.<N>.	All configurable entries are also tun-
       ables, and can be put directly into the loader.conf(5)  for  persistent
       configuration.

SEE ALSO
       ifconfig(8)

HISTORY
       The enic	device driver first appeared in	FreeBSD	14.0.

AUTHORS
       The enic	driver was written by Cisco UCS	team based of the DPDK driver.

FreeBSD	13.2			 Sept 7, 2022			       ENIC(4)
NAME | SYNOPSIS | DESCRIPTION | HARDWARE | CONFIGURATION | SEE ALSO | HISTORY | AUTHORS

Want to link to this manual page? Use this URL:
<https://man.freebsd.org/cgi/man.cgi?query=enic&sektion=4&manpath=FreeBSD+14.2-RELEASE+and+Ports>

home | help