FreeBSD Manual Pages
QLXGBE(4) Kernel Interfaces Manual QLXGBE(4) NAME qlxgbe -- QLogic 10 Gigabit Ethernet & CNA Adapter Driver SYNOPSIS To compile this driver into the kernel, place the following lines in your kernel configuration file: device qlxgbe To load the driver as a module at boot time, place the following line in loader.conf(5): if_qlxgbe_load="YES" DESCRIPTION The qlxgbe driver supports IPv4 checksum offload, TCP and UDP checksum offload for both IPv4 and IPv6, Large Segment Offload for both IPv4 and IPv6, Jumbo frames, VLAN Tag, and Receive Side scaling, ability to se- lect either HW or Software LRO, when LRO is enabled (default HW LRO). For further hardware information, see http://www.qlogic.com/. HARDWARE The qlxgbe driver supports 10 Gigabit Ethernet & CNA Adapter based on the following chipsets: • QLogic 8300 series SUPPORT For support questions please contact your QLogic approved reseller or QLogic Technical Support at http://support.qlogic.com, or by E-mail at <support@qlogic.com>. SEE ALSO altq(4), arp(4), netintro(4), ng_ether(4), ifconfig(8) HISTORY The qlxgbe device driver first appeared in FreeBSD 10.0. AUTHORS The qlxgbe driver was written by David C Somayajulu at QLogic Corpora- tion. FreeBSD 13.2 April 1, 2013 QLXGBE(4)
NAME | SYNOPSIS | DESCRIPTION | HARDWARE | SUPPORT | SEE ALSO | HISTORY | AUTHORS
Want to link to this manual page? Use this URL:
<https://man.freebsd.org/cgi/man.cgi?query=qlxgbe&sektion=4&manpath=FreeBSD+14.0-RELEASE+and+Ports>